PLOW PUSHER 3056 JRB 420 XHD RUBB BLTEND
DEPT OF DEFENSE
Free. Verify your email, then we send one reminder only.
- Posted
- Sep 1, 2026
- Closes
- Sep 3, 2026 (in 2 days)
Similar opportunities open now
- PURCHASE AND INSTALL OF MULTIPLE COMPONENTS ON A 2026 FORD F-350OpenGENERAL SERVICES ADMINISTRATIONCloses today
- New AEBI Terratrac TT282 Slope TractorSame funderOpenDEPT OF DEFENSENo deadline listed
- Draft SOW and PSpec for Extendable Boom Forklift (EBFL)Same funderOpenDEPT OF DEFENSENo deadline listed
- Sources Sought-Head Loader with Mulching HeadOpenCOMMERCE, DEPARTMENT OFNo deadline listed
- Electric Motor RebuildSame funderOpenDEPT OF DEFENSENo deadline listed
At a glance
This is a government contract opportunity posted by DEPT OF DEFENSE in the all other transportation equipment manufacturing category. The deadline is September 3, 2026, 3 days from now.
Classification and identifiers
- Industry (NAICS)
- All Other Transportation Equipment Manufacturing (336999)
- Product or service (PSC)
- Miscellaneous Service and Trade Equipment (3590)
- Solicitation number
- W911S226U4159
- Contracting office
- W6QM MICC-FT DRUM
Who can apply
Small businesses can apply here. Check the eligibility details below to see if your organization fits.
Small Business Set Aside - Total
About this opportunity
The plow shall be a pusher plow with a 30-foot blade and with the top of the inside barrel being 56 inches from the ground. The plow shall have an integrated weld-in JRB 420 coupler, with each inner face measuring 29 3/8 inches from each other, and evenly spaced from the center. The end plates shall be made from 3/8-inch plate and shall be a maximum of 61 11/16 inches tall and maximum width of 41 3/8 inches. There shall be (3) square 11/16-inch holes with the centers positioned 3 inches, 19 inches, and 35 inches away from the front side of the plate, and 2 inches from the bottom of the plate. Each end plate shall have a 2 1/2-inch section at the end of each plate which will be bent away from the plow weldment. Each end plate shall have a 1 1/2-inch hole positioned at the top of the plate. ...